Darwin Ports / how to build whiterussian router firmware?

•

What is DaniWeb IT Discussion Community?

You're currently browsing the Darwin, X11 and BSD section within the Tech Talk category of DaniWeb, a massive community of 373,475 software developers, web developers, Internet marketers, and tech gurus who are all enthusiastic about making contacts, networking, and learning from each other. In fact, there are 3,944 IT professionals currently interacting right now! Registration is free, only takes a minute and lets you enjoy all of the interactive features of the site.

Join our community!

Please support our Darwin, X11 and BSD advertiser:

Thread Tools Display Modes

Views: 866 | Replies: 0

•

Join Date: Feb 2008

Posts: 4

Reputation: iching808 is an unknown quantity at this point

Rep Power: 0

Solved Threads: 0

iching808

Offline

Newbie Poster

Darwin Ports / how to build whiterussian router firmware?

Feb 26th, 2008

I what to flash a router (linksys WRT54G V7) with whiterussian firmware I downloaded for it, but when I run make from the whiterussian dir first it wouldn't work because it was not on a case sensitive fs. So I created a disk image with case sensitive mac fs, copied the folder there, but then when I try make in *that* dir it is not working.

this is from the terminal:

bash-3.2$ make
cp .config .config.test
scripts/configtest.pl
make -C toolchain install
cc -I./include -o /Volumes/OpenWRTbuild/whiterussian-0.9/toolchain_build_mipsel/utils/sstrip src/sstrip.c
src/sstrip.c:373:2: error: #error unkown endianness
make[2]: *** [/Volumes/OpenWRTbuild/whiterussian-0.9/toolchain_build_mipsel/utils/sstrip] Error 1
make[1]: *** [utils-compile] Error 2
make: *** [toolchain/install] Error 2
bash-3.2$

I suppose I'm really out of my depth here but I thought it would work

Any advice where to go to read up / start ?