| joshuu | Oct 30th, 2004 8:49 am | |
| windows protection error after adding tcpip protocol
I installed a new ethernet card and its driver in a compaq deskpro ep/sb series running a pentium III and 64 RAM. The problem is that if I add the TCP/IP protocal and then restarting it gives me a windows protection error and it won't pass through it even I restart.I have to use save mode to get to windows and upon removing the Tcp/ip it would start with no problem but now I cant be able to see the whole network.I really need to the Tcp/ip so that I can connect to internet.I would appreciate any ideas given to pass through this frustrating error . |
| thepom11 | Oct 31st, 2004 7:26 pm | |
| Re: windows protection error after adding tcpip protocol
Although the TCP/IP protocols are the same for dial-up networking and for LAN the settings can be very different. Suggest you check these settings, this in ME can best be done through the dial-up networking icon and not the network icon in the control panel.If using both you may need to notify your browser which connection type you are using. g,day. |
| All times are GMT -4. The time now is 9:06 am. | |
Forum system based on vBulletin Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.
©2003 - 2009 DaniWeb® LLC
