DaniWeb IT Discussion Community

DaniWeb IT Discussion Community (http://www.daniweb.com/forums/index.php)
-   Troubleshooting Dead Machines (http://www.daniweb.com/forums/forum122.html)
-   -   will not post (http://www.daniweb.com/forums/thread991.html)

drexel Aug 31st, 2003 12:46 pm
will not post
 
I bought a new computer with a MSI 865pe board. It will not post. No beeps! Please help.

cscgal Aug 31st, 2003 12:51 pm
Re: will not post
 
Is it getting power? Is the power supply "surging"? (I think I might've made up my own word) The only reason I ask is that happened to me once. New computer, new power supply. Hook everything up. Power on the power supply. It was bad. Sent a surge through all my hardware upon first turning it on. Fried everything.

drexel Aug 31st, 2003 12:53 pm
Everything seems to be getting power the P4 connector is pluged in and everything

cscgal Aug 31st, 2003 1:01 pm
Re: will not post
 
Turn the computer on with the case open. Can you see the motherboard LEDs lighting up? What, exactly, does the computer do? It just doesn't get past the BIOS settings, or what?

drexel Aug 31st, 2003 11:31 pm
It will not beep. It is getting power but no video signal and no post.

TallCool1 Sep 1st, 2003 12:47 am
Re: will not post
 
Quote:

Originally Posted by drexel
It will not beep. It is getting power but no video signal and no post.

Do the lights on the keyboard flash? That's the best indicator of system initialization. If not, it's probably the power supply or CPU.

RueB2sDe May 9th, 2007 10:48 am
Re: will not post
 
I would say that if your Keyboard lights do not blink, no beeping and no post it may be that the Hard Drive cable is either not plugged in completly or a jumper setting on the motherboard is set to the wrong IDE slot for post. I would reccomend to check the motherboard for the IDE or SATA connector. Try reseating it (uplug and replug) If it still fails it may be a possible jumper setting on Motherboard to set to correct bootup IDE or SATA Startup.

cguan_77 May 22nd, 2007 12:56 am
Re: will not post
 
hi drexel,

try to boot up your computer without the data cables, connected to the motherboard, so you can isolate other problems...then power on your computer check if the keyboard led's flash, checked also if the cpu fan rotates..then if the keyboard led's didn't flash and cpu fan doesn't rotates , then try to double check all your jumper settings..

RueB2sDe May 22nd, 2007 10:27 am
Re: will not post
 
You might also need to replace your CMOS Battery as well. Make sure it is seated well on the motherboard. If you CMOS battery is not installed correctly or it needs to be replaced the system will not boot at all. No fans, no power (sometimes you see limited power such as a dimmed hdd light.)

RueB 2s De

dcc May 22nd, 2007 11:37 am
Re: will not post
 
If this computer is new it should still be under warranty. Take it back and let them sort it out before you do something that will give them an excuse to void the warranty.


All times are GMT -4. The time now is 4:43 pm.

Forum system based on vBulletin Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.
©2003 - 2009 DaniWeb® LLC