My first problem on this forum:) hard drive related

Reply

Join Date: Jan 2005
Posts: 2
Reputation: Griffinman is an unknown quantity at this point 
Solved Threads: 0
Griffinman Griffinman is offline Offline
Newbie Poster

My first problem on this forum:) hard drive related

 
0
  #1
Jan 3rd, 2005
Ok i just bought a new 200 gig maxtor hard drive ata 133 how do i get it to be recognized when i boot up my comp i want to put my operating system on there
Last edited by Griffinman; Jan 3rd, 2005 at 1:08 am. Reason: Fixed problem
Reply With Quote Quick reply to this message  
Join Date: Nov 2004
Posts: 571
Reputation: moderate_rock48 is an unknown quantity at this point 
Solved Threads: 0
moderate_rock48's Avatar
moderate_rock48 moderate_rock48 is offline Offline
Posting Pro

Re: My first problem on this forum:) hard drive related

 
0
  #2
Jan 3rd, 2005
Have you hooked it up to your comp and booted it up yet, or are you have problems with it. It should already be set to master jumper settings. If you can locate the jumpers(usually on the side or bottom) just check and make sure they are set to master, and there should be a diagram on the top(to show how to set the jumpers)
My karma ran over your dogma.
Reply With Quote Quick reply to this message  
Join Date: Jan 2005
Posts: 2
Reputation: Griffinman is an unknown quantity at this point 
Solved Threads: 0
Griffinman Griffinman is offline Offline
Newbie Poster

Re: My first problem on this forum:) hard drive related

 
0
  #3
Jan 3rd, 2005
Thanks a lot problem solved :mrgreen:
Reply With Quote Quick reply to this message  
Reply

This thread is more than three months old.
Perhaps start a new thread instead?
Message:


Thread Tools Search this Thread



About Us | Contact Us | Advertise | DaniWeb | Acceptable Use Policy | RSS Feed

©2003 - 2009 DaniWeb® LLC