setting up VD-RW master & CD-R slave

Reply

Join Date: Mar 2005
Posts: 1,522
Reputation: dcc is an unknown quantity at this point 
Solved Threads: 36
dcc dcc is offline Offline
Posting Virtuoso

setting up VD-RW master & CD-R slave

 
0
  #1
Jun 27th, 2005
I have a CD-R, and was given a CD-RW, and would like to set them up as slave and master. I know about the jumper on the rear of the units, and the data and power cords, but what do I need to do to coordinate the two?
I removed the CD-R and installed the CD-RW with Nero 5.5 before I knew that I could use both drives, so I'll re-install the other. Do I need to install the Nero again for the second unit? What else do I need to do?
Reply With Quote Quick reply to this message  
Join Date: Mar 2005
Posts: 1,522
Reputation: dcc is an unknown quantity at this point 
Solved Threads: 36
dcc dcc is offline Offline
Posting Virtuoso

Re: setting up CD-RW master & CD-R slave

 
0
  #2
Jun 27th, 2005
Never mind... the CD-R is toast.
Reply With Quote Quick reply to this message  
Reply

This thread is more than three months old.
Perhaps start a new thread instead?
Message:


Thread Tools Search this Thread



About Us | Contact Us | Advertise | DaniWeb | Acceptable Use Policy | RSS Feed

©2003 - 2009 DaniWeb® LLC