 |  |  |  |  |  |  |  |
Computer won't start after power outage.
 |
Another poster seems to have a similar problem below but I didn't want to hijack his thread so here goes.
The power to my subdivision cycled off and on rapidly about 15 times the other morning. Afterwards my computer (HP a530n) wouldn't start. it gives no lights on the front and you don't hear anything inside happening (no fans spin up) on the back of the Computer the PSU LED is flashing.
I went through the online troubleshooting guide from HP and got to the point where you disconnect the PSU from everything to give you a solid green (if PSU is good) and then plug in things until the LED flashes again showing the fault. Well the first thing I unplugged after removing from the PSU was the Motherboardand decided I would go ahead and check the PSU LED as I disconnected things. Sure enough the PSU LED went solid green. So I decided to check out the PSU just to be sure by swapping it out with another that I had nearby in another desktop (call it computer #2). The PSU from Computer 2 went into Computer 1 and I get the fans to spool up for about a second before it powers back down. So I took the PSU from Computer 1 and placed it in Computer 2 and it started right up with no problems whatsoever.
So here is my question:
To me it looks like I have a bad Motherboard. Do you agree?
Or could it be one of the cards attached to the motherboard that is bad and that I need to unplug the individual cards from the motherboard to check them?
The power to my subdivision cycled off and on rapidly about 15 times the other morning. Afterwards my computer (HP a530n) wouldn't start. it gives no lights on the front and you don't hear anything inside happening (no fans spin up) on the back of the Computer the PSU LED is flashing.
I went through the online troubleshooting guide from HP and got to the point where you disconnect the PSU from everything to give you a solid green (if PSU is good) and then plug in things until the LED flashes again showing the fault. Well the first thing I unplugged after removing from the PSU was the Motherboardand decided I would go ahead and check the PSU LED as I disconnected things. Sure enough the PSU LED went solid green. So I decided to check out the PSU just to be sure by swapping it out with another that I had nearby in another desktop (call it computer #2). The PSU from Computer 2 went into Computer 1 and I get the fans to spool up for about a second before it powers back down. So I took the PSU from Computer 1 and placed it in Computer 2 and it started right up with no problems whatsoever.
So here is my question:
To me it looks like I have a bad Motherboard. Do you agree?
Or could it be one of the cards attached to the motherboard that is bad and that I need to unplug the individual cards from the motherboard to check them?
Well I went ahead and disconnected all cards except the video card and tried to start it up with both PSUs. As before the computer does not respond at all with the original PSu and only respond for a bout a half second with the PSU from my old computer.
One thing that I forgot to mention before was that the motherboard has a 4 pin power point and the old psu that I was using for testing does not have that connector. Everything that I have read says that AMDs don't require that 4pin power connected to startup just that it will be unstable.
So If someone would please help me out here that would be great.
What do you think the problem with my computer is?
a) the motherboard/cpu is bad
b) the psu is bad
I think it is option a but any thoughts or suggestions before I go out and order a new mobo would be greatly appreciated.
One thing that I forgot to mention before was that the motherboard has a 4 pin power point and the old psu that I was using for testing does not have that connector. Everything that I have read says that AMDs don't require that 4pin power connected to startup just that it will be unstable.
So If someone would please help me out here that would be great.
What do you think the problem with my computer is?
a) the motherboard/cpu is bad
b) the psu is bad
I think it is option a but any thoughts or suggestions before I go out and order a new mobo would be greatly appreciated.
Pardon me if I snicker here, but what do you suppose they mean by being unstable. You will need a PSU with the P4 connector if the motherboard has that connector.
I was afraid of that. Although like I said above I have seen multiple things online from people saying that the AMDs WILL work without that 4 pin connector.
I am just trying to figure out what the problem is without having to go out and buy stuff that I don't need.
Any other helpful responses are appreciated.
I am just trying to figure out what the problem is without having to go out and buy stuff that I don't need.
Any other helpful responses are appreciated.
There is an adaptor that will allow you to use the 20 pin connector type PSU. It still won't have the p4 connector which can be a problem with some motherboards. I built a new machine recently that had the 24 pin connector and the p4 connector and had been advised from the tech support that there may be an issue with the system fully powering up without the p4 connector.
What motherboard and CPU are you using?
What motherboard and CPU are you using?
•
•
•
•
Originally Posted by Nucleartiger 
Well I went ahead and disconnected all cards except the video card and tried to start it up with both PSUs. As before the computer does not respond at all with the original PSu and only respond for a bout a half second with the PSU from my old computer.
One thing that I forgot to mention before was that the motherboard has a 4 pin power point and the old psu that I was using for testing does not have that connector. Everything that I have read says that AMDs don't require that 4pin power connected to startup just that it will be unstable.
So If someone would please help me out here that would be great.
What do you think the problem with my computer is?
a) the motherboard/cpu is bad
b) the psu is bad
I think it is option a but any thoughts or suggestions before I go out and order a new mobo would be greatly appreciated.
Try this. Remove the power cord from the computer. Open up the box and disconnect the power supply from the mother board. Wait till the light on the power supply stops flashing (total discharge), then plug the power cord back in - the light should stay green after a second or two. Once the light is green - plug the power supply back into the mother board. If you see a solid green light on the mother board, turn the machine on RIGHT NOW!!
It will run till you turn it off.
Yes, something in the mother board is dying, but if your machine still runs, MAKE A BACKUP!
•
•
Join Date: Jan 2007
Posts: 479
Reputation: 
Solved Threads: 21
Posting Pro in Training
those on and off voltage cycles also meant POWER SURGES, bad news for any system board. a new or reprogrammed BIOS is fairly cheap. if that doesn't work then it's time to consider another board, seems to me you've tried everything else.
•
•
•
•
Originally Posted by KevinTaute
I have a simular problem just about everytime the power goes out.
Try this. Remove the power cord from the computer. Open up the box and disconnect the power supply from the mother board. Wait till the light on the power supply stops flashing (total discharge), then plug the power cord back in - the light should stay green after a second or two. Once the light is green - plug the power supply back into the mother board. If you see a solid green light on the mother board, turn the machine on RIGHT NOW!!
It will run till you turn it off.
Yes, something in the mother board is dying, but if your machine still runs, MAKE A BACKUP!
I'm having a similar problem. I took apart my computer to clean some of the dust out (something I've done in the past). Once I put everything back together I wasn't able to get it to start.
The LED on the motherboard is lit, but when I press the power button nothing happens.
I tried the method mentioned above (unplugging the power, unplugging the power supply from the mobo, plugging the power back in and then plugging the motherboard back in). Using this method, as soon as I plug the motherboard in the fans spin for a second or two then stop. The power button still does nothing.
I've tried jump starting it, switching the reset and power buttons (ie using the reset button as the power button), and I've triple checked that everything is connected correctly. Anyone have any insights into whats wrong? I don't think the motherboard is bad, as I mentioned the LED lights up indicating the motherboard has power.
The LED on the motherboard is lit, but when I press the power button nothing happens.
I tried the method mentioned above (unplugging the power, unplugging the power supply from the mobo, plugging the power back in and then plugging the motherboard back in). Using this method, as soon as I plug the motherboard in the fans spin for a second or two then stop. The power button still does nothing.
I've tried jump starting it, switching the reset and power buttons (ie using the reset button as the power button), and I've triple checked that everything is connected correctly. Anyone have any insights into whats wrong? I don't think the motherboard is bad, as I mentioned the LED lights up indicating the motherboard has power.
|
Similar Threads
- Computer wont turn on after power outage (Troubleshooting Dead Machines)
- Dell won't start after power outage (Troubleshooting Dead Machines)
- I had a power outage the day and now my computer won't boot. (Troubleshooting Dead Machines)
- power led on but computer wont start (Troubleshooting Dead Machines)
- hp wont start up - atx power clicking noise (Troubleshooting Dead Machines)
- Computer from Europe won't start up (Cases, Fans and Power Supplies)
- Protect Your Files During a Power Outage (Windows tips 'n' tweaks)
Other Threads in the Troubleshooting Dead Machines Forum
- Previous Thread: No display when turning on PC
- Next Thread: Ok very odd system issue please help
| Thread Tools | Search this Thread |
You need to join our community in order to build your list of favorite forums. You can visit the forum index for a listing of all forums.
Related Forum Features
Latest Troubleshooting Dead Machines Posts
- Today's Posts
- Unanswered Threads
appliances beep bioslosingharddrived bioslosingsettings black bsod citrix cmosbattery compaq cpu dead delldimension4500 failure giving harddrive laptop linux mac mobo neverbuyinspiron1525 nodisplay nopower operatingsystemnotfound osnotfound pc power ram redhat screen supply ubuntu virtualbox virtualization virtualmachines vmware xen
