Computer's OS had become damaged or corrupt, and was giving a myriad of glitches and hangs. Clean install was performed including FDISK, repartitioning, format, preinstall virusscan, run on this computer from another computer bridged to it, and then reinstallation of OS. All operations went without a hitch, but, now The following message occurs:

Standard Mode: Fault outside of MS-Dos Extender
EC=0000 CS=307 IP=3E03
AX=0080 BX=0000 CX=0002
DX=0000 SI=0180 DI=0000 BP=015A
DS=0277 ES=027F SS=027F SP=013C

Please remove any Floppy disks from your drives and press any key to restart your system.

When a key is pushed the computer reboots, but goes into a loop of showing the error message, you push a key to reboot, and it reboots to the same error message.

The machine will not boot to safe mode although I am able to get to the DOS prompt by booting with an emergency startup CD. There are no post or beep codes observed but am able to get into the bios using ESC and F1 during the unsuccessful boot employing the HD. The computer has no floppy drive, so several of the the attempts to remedy the situation have been met with limited sucess

Any help would be appreciated,
Dan

Toshiba Tecra 8100 Laptop
850 MHz Pentium III
512 MB SDRAM
20 MB HD
Windows XP Home

instead of bridging do everything from that computer.

go to your hdd manufactures site get the util and do a zero write.after that install windows it will do another format and partition.

Like Titan said you should run Fdisk, Partitioning and installing from the laptop. I have run into many conflicts when installing windows via another computer (if thats what you are doing). Maybe checking to make sure the hdd doesn't have bad sectors might be the go too. Hope it helps

Thanks for the suggestion. I appreciate your reply. I think I may have fixed it though, before I got to read your reply. I managed to boot the computer to the CMD Prompt, in safe mode with an OEM 95 CD. Then I "hot swapped" the 95 CD with the XP and copied the generic autoexec and config files over from the CD to the respective directories on the C: drive. Then I rebooted in normal mode and it booted to the correct OS, but with a bunch of errors. Then I ran a repair from the XP install CD. Everything has been working fine since for the last few days, but if it happens again, I'll use your suggestion.

Thanks for Your Time and consideration,
Dan

Just glad you got it going Bud.