Problems with setting up Netgear WG602 Wireless Access Point

The previous user may have changed the default IP address or some other configuration settings; you should do a hard reset of the router if you haven't done so yet.

Here are the reset instructions from Netgear:

1. Press the reset button on the back until the test light blinks. This takes about 10 seconds. (To avoid accidental resets, the small button is recessed. Use a pen or paperclip to access it.)
2. Release the button.
3. Wait for the router to reboot.
4. Log in with the default password. If the router was not cleared, try these additional steps AFTER the router has finished rebooting.
5. Unplug the router's power.
6. Press and hold the reset button. While the button is held down, reconnect router's power.
7. Continue to hold the reset button for 20 seconds after reconnecting the power.
8. Wait for the router to reboot.
9. Log in with the default password.

Yes- the instructions on Netgear's site did use the word "router", but they apply to any of their devices which have a reset switch.

From one of the computers that is directly wired to the router, can you sucessfully ping the default IP of the Access Point?:

* Click on the "Run..." option in your Start menu.
* In the "Open:" box of the resulting window, type "cmd" (omit the quotes) and hit Enter. This will bring up a DOS window.
* At the DOS prompt, type the following commands, and then hit Enter. You should get 4 positive replies, followed by some sumary information.

ping default_IP_address_of_WG602

Hmm... it's starting to look like something might be squiffy with the Access Point, but let me check at least one more thing before we consider the possibility of a faulty AP. On the computer which you ran the ping command, please do the following:

Open a DOS window again and at the DOS prompt, type the following command and hit Enter. You won't see any result from the command, but when it completes, a second prompt with a flashing cursor will be displayed; close the DOS box once that happens:
ipconfig /all >"%userprofile%"\desktop\ipconfig.txt

The above command will have created a text file on you desktop named ipconfig.txt; double-click on the file to open it in Notepad, and then cut-n-paste the file's contents in your next post here.

You're welcome- help is why we're here (although I'll feel a heck of a lot better about this if we can actually get it working) :mrgreen:

Your IP addressing info is correct in terms of what should be compatible with the access point, so I'm not sure why you can't ping the beast. Let's see if the RP614 router even senses that the AP is attached to it. If it does, we will also be able to determine the IP address that the AP is using:

* Open your web browser and log in to the router by going to the following address: http://www.routerlogin.net

* Enter the username and password. The default user is admin; the default password is password.

* Under the Maintenance section/option, go to the Attached Devices section and see if your can determine which IP addresses are assigned to which devices (the AP should obviously be one of those devices.)