I dunno about all that IP address stuff Belrog recommended; seems rather convoluted and unecessary as you would simply choose Dynamic IP Address in the DI-524 and be served IP addresses by the NB1300.
You would thus ensure that on the DHCP menu in the DI-524 you have DHCP server enabled.
Presumably the above's the case because it worked with an Ethernet connexion.
On the Wireless menu, you might choose a channel other than the default if that happens to be the channel of your wireless telephone system or the channel of your neighbour's wireless WAN. I assume that at this stage you haven't set Encryption.
I also assume that you haven't set Filters (MAC Filters) in the Advanced menu. If you have set it to Only Allow, you'd need to Disable that if the MAC address you've provided is not the same as the MAC address of your computer's Wireless card.
You didn't mention what, if any, connect error warning you were receiving.
However these problems (although they shouldn't occur), are sometimes resolved by going into RUN --> CMD, then:
IPCONFIG /Release
IPCONFIG /RENEW
Netsh winsock reset if the above alone don't do the trick.
The above commands would apply if the PC reportes that it couldn't obtain an IP address from the router.
I hope that's not too confusing. But it's the stepwise approach, I reckon.
Reputation Points: 47
Solved Threads: 144
Posting Virtuoso
Offline 1,729 posts
since Aug 2007
Unsolved 
and i cant go on the set up page to go through the wizard again 
