Man watch this topic get hammered with answers. Did you install any type of software then noticed this? In your task manager under processes what is running? Get back to us.
MAD_DOG
Practically a Master Poster
626 posts since Feb 2002
Reputation Points: 58
Solved Threads: 14
Hello,
My *guess* is that you have Gaobot virus or the Sasser. There is an extensive writeup at www.symantec.com about it. You did say that you scanned with an antivirus tool... were the definitions current? I would get *today's* definitions and look at it.
It is also unfortuntate that Windows doesn't have a TOP command to see how much CPU time has been consumed historically by a particular process. On my Mac OS X box, I was able to tell that the Palm Pilot software wasn't consuming many resources in realtime, but over the course of the week, that time builtup a lot, and I realized the "leak".
Good Luck.
kc0arf
Posting Virtuoso
1,937 posts since Mar 2004
Reputation Points: 121
Solved Threads: 57
I think your problem is software related, rather than hardware related. I'd suggest the heart of it lies in your comment:
"There might have been some other installed software because I let my family use my computer too."
You are unaware what's occurred on your system, and in one way or another Spyware or other problems will likely be slowing your system down. Please work through the suggestions made in the "Helping Yourself" sticky in the Security section of the Forum, and then report back here once you've eliminated those software issues.
Catweazle
Grandad
4,335 posts since Mar 2004
Reputation Points: 229
Solved Threads: 149
Make sure that your spyware and AntiVirus tools are the latest versions and updated.
Have you also used 'Disk Cleanup' to clean out temp files, cache files and so on. If those become 'clogged up' then your system performance will suffer.
Catweazle
Grandad
4,335 posts since Mar 2004
Reputation Points: 229
Solved Threads: 149
I still think your problem is software related, but please post your system specifications so we have a measure to judge by.
Your processor speed, amount of RAM installed, display card and other hardware info is rather necessary to a hardware discussion.
Catweazle
Grandad
4,335 posts since Mar 2004
Reputation Points: 229
Solved Threads: 149
Roghto then. Here's the hardware issues I can think of:
Has a change been made that's reset the clockspeed of your processor's front side bus? The setting should be 133MHz, to give a 266MHz fsb speed. If it's been reset to 100MHz, then yout processor will be performing nearly as bad as a Duron.
Did you set your RAM to run at a suitable speed? Ideally, you should have all RAM running at 266MHz, to match your front side bus speed, and have things running 'in sync'. If you have your RAM set faster, it can actually slow your system down.
Is the slowdown continual and permanent? If your system starts fine, then slows down and cradhes after a bit of use, that could indicate an overheating problem.
There are no other issues than these, for hardware, that I can think of which would cause a permanent and pervasive system slowdown. As I've said, I believe your problem is software related, and you should look at what you have installed, remove anything you dan't need or use, and attend to adequate system maintenance (as you've said you've done). Make sure you don't have multiple 'system tweaking' and 'troubleshooting' software programs installed. Apart from having a couple of utilities for spyware/malware detection and removal, having multiple instaces of system utilities is one of the worst things you can do to your system.
If you've eliminated all the stuff in that outline as potential causes, perhaps you should try a format/install to freshen things up and get your Windows installation working smoothly again.
Catweazle
Grandad
4,335 posts since Mar 2004
Reputation Points: 229
Solved Threads: 149
Using a Tool such as GoBack would certainly disable access to recently added programs etc.
A point to consider, that hasn't been mentioned before, is that perhaps you should consider backing up all your data, and performing a clean install of your system. It's an unpopular suggestion to make, but when someone wishes to maintain peak performance for games, particularly with a budget range display card such as the one you have, regular format/installs can be a wise procedure to follow.
Catweazle
Grandad
4,335 posts since Mar 2004
Reputation Points: 229
Solved Threads: 149
That happens, I'm afraid, because Windows XP isn't designed to handle a motherboard upgrade. The Product activation checking is kicking in, failing to recognise the hardware in place (a motherboard change is equivalent to quite a number of component changes) and stopping your Windows installation from being able to Boot up.
There are ways to get around it, but now that you've allowed the system to attempt booting into Windows, it's likely to be a difficult and perhaps impossible job.
The best answer to your dilemma, by far, is to Boot from your Windows CD, and install again fresh and new. A repair install may correct it, and is worth trying, but there's no guarantees.
Catweazle
Grandad
4,335 posts since Mar 2004
Reputation Points: 229
Solved Threads: 149