dell optiplex gx1

Hi dear, I bought an used dell optiplex gx1 and start but and say: press for system setup (and I do it but nothing happen> my key board is ok I allredy try it with another computer and work) also say erro 8602 auxiliare device failure. pxe-moo:initializing landesk service agent for 3c90, type de password and... press to leave p/w security enable, press to disable p/w (and I done it and nothing) then say enter password. What can I do to disable that p/w get to the setup so I can format the H/D and install Windows 98se Thank you before de hand you could e-mail me at [email]sergioperez20@msn.com[/email] thanks a lot. :sad:

sergioperez20

Newbie Poster

1 post since Sep 2003

Reputation Points: 10

Solved Threads: 0

8 Years Ago

0

look on the motherboard for a jumper to reset the bios to default usuall near the bios chip ,or remove the motherboard battery for a while to restor the default bios.

caperjack

I hate 20 Questions

Team Colleague

13,069 posts since Aug 2003

Reputation Points: 1,064

Solved Threads: 812

5 Years Ago

0

Hi dear, I bought an used dell optiplex gx1 and start but and say: press for system setup (and I do it but nothing happen> my key board is ok I allredy try it with another computer and work) also say erro 8602 auxiliare device failure. pxe-moo:initializing landesk service agent for 3c90, type de password and... press to leave p/w security enable, press to disable p/w (and I done it and nothing) then say enter password. What can I do to disable that p/w get to the setup so I can format the H/D and install Windows 98se Thank you before de hand you could e-mail me at [EMAIL="sergioperez20@msn.com"]sergioperez20@msn.com[/EMAIL] thanks a lot. :sad:

When you open the case (facing the front), on the bottom left of the motherboard you will see some jumpers and the board will be labeled (albeit very small). Remove the jumber on the label "passwd" and you should be able to boot normally and even access the BIOS. I had the same problem and did this with success.

willshell

Newbie Poster

1 post since Jul 2006

Reputation Points: 10

Solved Threads: 0

4 Years Ago

0

I inherited one of these too. Dead. Power would turn fans, but no boot activity. No Flash screen to monitor. I pulled all the memory Simms Out of it and turned it on. This forced the BIOS firmware to beep complaint codes. Put one 256Meg Simm back in. Then it posted Dell Flash Screen on power up - and F2 to enter Bios Setup.

BeefCake

Newbie Poster

1 post since Nov 2007

Reputation Points: 10

Solved Threads: 0

3 Years Ago

0

how do u open this thing? Im having some trouble

jihessa

Newbie Poster

3 posts since Jan 2009

Reputation Points: 10