Did you try starting it up again after turning it off (by holding down the power button for about three seconds, unplugging it, or turning the power supply off with the switch that's on it) and leaving it alone for a few minutes? If you haven't, turn the switch on the power supply to the off position, leave the machine alone for a few minutes, turn the switch back on, and try to start the machine up.
If the machine refuses to turn on, what sounds do you hear it making? Do the fans run? Do the lights flash? Do you hear any beeps? Do you hear the drives being accessed?
I was trying a bunch of stuff last night.
These are on
1. fan on board
2. fan on case
3. lights on CD Drive (flashing)
4. light on case (PC power light) ( stays on then Flashes about every 20 - 30 seconds)
5. light on case (PC reset button light) ( stays on then flashes after PC power light)
6. No beeps or sounds from boot up
7. hard drives sound like they are spinning from power on, but nothing else.
What I've done..
1. unplugged power cord, left off over night, plugged back in same thing.
2. disconnected CD drive and put boot floppy in A:\.... (Floppy is not being accessed or turned on.) (worked before this happened)
3. disconnected On hard drive at a time( I have two 80gb and 300 gb) I would leave one in and one out and tried to boot, didn't work.
4. Disconnected both and tried to boot up cpu and board, nothing.
5. disconnected all drives floppy, cd, both hard drives and my 512 ddr ram I add... still no boot on screen
Throughout this whole process my screen has not been getting video. So I plugged in a different monitor, same thing, no video is being sent out and monitor goes to power save mood. also I dont get any lights on my keyboard. Usually the num lock, caps lock and one more would light up during boot up process. NOTHING.... I'm ready to take an axe to it :mad: :twisted: . Please help.