This machine started locking up randomly and even during boot up - then quit booting at all. When powering on, I hear the hard drive activate and a fan like sound running, but nothing else including a blank screen. I noticed the cpu fan not running so I replaced that. The problem still existed. I suspected damage to the processor still thinking that it was a heat problem from the fan not running, so I replaced the cpu. Still same problem. My next step was the motherboard, which came with yet another cpu, but this didn't fix anything either. I know this shouldn't matter, but I had another harddrive so I went ahead and swaped that, too. Also, just wanting to rule out a bad monitor, I hooked it to a desktop monitor, but had the same blank screen. I'm at a loss for anything else to replace and check. Any help is appreciated.
I tested the power supply output with a multimeter and a 10 ohm 10% resistor to provide a load. It read at 15+ volts so I am assuming it to be a good supply. Can bad RAM also keep the fan from not working and the monitor not coming on at all?
You need to try a know good spare RAM to try in it and see if it comes up. I've seen many systems boot to a blank screen and after exchanging RAM it boots quite well, so try changing Memory.
Faulty RAM can do all sorts of strange things, so I wouldn't rule it out (especially given that you seem to have replaced almost all of the the other major components).
Also: this may be a long shot, but I know that at least a couple of models of laptops will start to exhibit symptoms (including locking up and/or not booting up properly) if either their main battery pack or the CMOS/motherboard battery are failing.
Unfortunately, I'm not very familiar with the Tecra laptops, so I can't say specifically what other components you might want to check.
This machine started locking up randomly and even during boot up - then quit booting at all. When powering on, I hear the hard drive activate and a fan like sound running, but nothing else including a blank screen. I noticed the cpu fan not running so I replaced that. The problem still existed. I suspected damage to the processor still thinking that it was a heat problem from the fan not running, so I replaced the cpu. Still same problem. My next step was the motherboard, which came with yet another cpu, but this didn't fix anything either. I know this shouldn't matter, but I had another harddrive so I went ahead and swaped that, too. Also, just wanting to rule out a bad monitor, I hooked it to a desktop monitor, but had the same blank screen. I'm at a loss for anything else to replace and check. Any help is appreciated.
hope this would help.....
i had the same problem before with my tecra 8100, i resolve it by adding a paper or a silicon to the clam to push the ground wire of the lcd making sure that it touches the frame or body..... due to the flipping of the lcd, the ground wire gets pulled loosing contact to the body or frame......
becareful when taking out the frame of the lcd, its soft, it breaks easily...
Hi , I have one these too. Try reseating the memory. You may also need to place a thin piece of card between ram and cover. The memory slots on alot a laptops are cr-p, but then again if they made them right they would need to go in for repair so often.
from what i have experience, when replacing memory or anything to ur laptop, always take the battery out and make sure power plug is not connected to the laptop...... by doing this will reset ur board and reset the registered memory or any other hardware from ur laptop, in most cases, tecra 8100 wont boot is because when u replace something without even taking the battery out, causing the laptop to malfunction and experience no startup......
sounds like you need a new power supply unit,see if you can swap the power supply with someone with a proven working power supply of the same type,saves cash buying one but its the only component you havent changed,if it works then buy new one
No one has posted to this discussion for at least three months. Please let old threads die and do not reply to them unless you feel you have something new and valuable to contribute that absolutely must be added to make the discussion complete. Otherwise, please start a new thread in this forum instead.
Unsolved 
Offline 
