944,120 Members | Top Members by Rank

Ad:
Dec 2nd, 2006
0

PC Monitor(s) keep returning NO SIGNAL analog!

Expand Post »
I just got a new Overdrive PC less than 24 hours ago.

The PC has a Core2 Duo E6700 processor, an XFX 7950 GX2 1GB ram graphics card (two DVI ports), and a 22" LCD Viewsonic monitor with built-in speakers, a DVI port, and an Analog port.

I follwed the set-up instructions very closely. When everything was hooked up, and I powered up the PC, no picture displyed on the monitor (both the PC and the monitor were turned on, of course). After a couple of tries, FINALLY, a picture displayed on the screen. I had no problems, All of the software I was supposed to install was already installed, and I could install games and play them. But I needed to restart the computer then. and then a couple more times. I didn't have any trouble getting a picture to appear on the screen after restarting/shutting down. The picture looked simply fantastic. I played F.E.A.R., GRAW, Battlefield 2, and Oblivion all at maxed out settings, at highest resolution with no problems. It seems that once I get past startup, and the monitor gets a signal, I don't have any problems.

I thought it would be best to shut my computer down after I was done. BIG MISTAKE...

The next morning I am having no luck with getting a picture to appear on the screen, after several attempts at restarting the computer. It's saturday (no tech support for the weekend, so I'm pretty much barred from my new PC!). I hadn't changed anything either. I've tried hooking up just the DVI, just the Analog, and both of them. Nothing works! I tried using a CRT monitor with analog and still, no signal. My PC just decided to give up on me... Does it matter if I have my monitor plugged in a protected circuit or not? I thought that was only the PC.

It seems like the PC runs just fine, it starts up normally and shuts down normally. It's just that the monitor won't get a signal! I've tested it on another computer and it works just fine.

I've never been so frustrated in my life. Any help would be much appreciated.

Edit: Oh and, also, the monitor plays no sounds when I start up or shut down the computer.
Last edited by TotalOblivion; Dec 2nd, 2006 at 3:39 pm. Reason: Additional Info.
Similar Threads
Reputation Points: 10
Solved Threads: 0
Newbie Poster
TotalOblivion is offline Offline
3 posts
since Dec 2006
Dec 5th, 2006
0

Re: PC Monitor(s) keep returning NO SIGNAL analog!

Did you try other DVI jack?

From the looks of it, your VGA is dying (or almost dead). You should try your PC with known good VGA to make sure.
Reputation Points: 230
Solved Threads: 45
Posting Virtuoso
Chaky is offline Offline
1,985 posts
since May 2006

This thread is more than three months old

No one has posted to this discussion for at least three months. Please let old threads die and do not reply to them unless you feel you have something new and valuable to contribute that absolutely must be added to make the discussion complete. Otherwise, please start a new thread in this forum instead.
Message:
Previous Thread in Troubleshooting Dead Machines Forum Timeline: Compaq Armada M700 wont Boot HELP!!!!!
Next Thread in Troubleshooting Dead Machines Forum Timeline: Fried my Compaq H3975???





About Us | Contact Us | Advertise | Acceptable Use Policy
Forum Index | Build Custom RSS Feed


Follow us on Twitter


© 2011 DaniWeb® LLC