Hello
I've just set up a new home wireless network on my dell laptop and I would like to wirelessly connect my printer again. When the installer detects the printer, the installation program freezes and I get the message HP Installer UI Plug is not responding. I have Windows 7, an HP Photosmart c4780 printer and run MacAfee security. Any help would be appreciated.
rita.piillangill
0
Newbie Poster
Recommended Answers
Jump to PostTry by temporarily disabling McAfee. If you can install it, then you can re-enable McAfee security.
All 3 Replies
rubberman
1,355
Nearly a Posting Virtuoso
Featured Poster
Try by temporarily disabling McAfee. If you can install it, then you can re-enable McAfee security.
rita.piillangill
0
Newbie Poster
Just the firewall?
rita.piillangill
0
Newbie Poster
Right now I'm reconfiguring the printer in the HP configure a network device. It's been running(reconfiguring) for a while. Should I start the USB to wireless over again after the firewall is turned off, or will it work mid-configuration?
Be a part of the DaniWeb community
We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.