Posts
 
Reputation
Joined
Last Seen
0 Reputation Points
0% Quality Score
Upvotes Received
0
Posts with Upvotes
0
Upvoting Members
0
Downvotes Received
1
Posts with Downvotes
1
Downvoting Members
1
0 Endorsements
Member Avatar for chameleon

Hello everyone, setting up a new system and have a problem. The connector my case came with for the Power LED is a 3 pin female connector but my motherboard only only has 2 pins available to connect the power wire. Is there anything I can do to get this …

Member Avatar for Rik_
0
302
Member Avatar for chameleon

I have a laptop with an integrated Intel Wireless G network card that once worked flawlessly with my Linksys 802.11G router. Now all of a sudden, I can connect to the router (I know this because when I run IPCONFIG it shows the correct default gateway of 192.168.2.1 and it …

Member Avatar for Mr.Cz91
0
1K
Member Avatar for w0rdie

I was running the ECS K7S5A, I just got my new ECS L7S7A2 board, moved all my stuff over to it, but no display on post. I did all the typical stuff, disconnected everything, reset CMOS, reseated the card, etc, etc-- nothing. Everything seems to be working fine other than …

Member Avatar for psdesai
0
388
Member Avatar for chameleon

Recently, Id say within the last month, my computer has began to shut down, as in turn off, on its own. No warnings from windows, it just shuts down. Does not restart. Typically after it shuts down I press the power button, and it takes about 15-20 seconds before I …

Member Avatar for chameleon
0
107
Member Avatar for chameleon

New problem I'm experiencing on a Win 2k box that I have not seen before. PC has fully funtional internet, file sharing capabilities in Safe Mode, but has suddenly stopped working in regular windows mode. System contains no viruses, has been swept for spyware and I cleaned out any remaining …

Member Avatar for chameleon
0
103
Member Avatar for chameleon

Hello everyone, have a new wireless problem here I cant seem to tackle. Its a Dell Dimension D800 running WinXP SP2. Problem is the wireless connection always shows I am connected and shows an excellent signal and an IP address but it only allows me to browse websites and AIM …

Member Avatar for chameleon
0
221
Member Avatar for chameleon

Ridding this computer of viruses and spyware except for this one stubborn dll logm.dll located in the Windows/System32 Folder. AVG is telling me that the file is infected with the trojan house BackDoor.Agent. I can not delete, heal or change the permissions to this file even in safe mode. This …

Member Avatar for dlh6213
-1
182
Member Avatar for chameleon

Hello everyone, Our building has 15 computers networked via 2 Switches, not routers, though we do have a DSL line going into the uplink to deliver internet access throughout the network. My question is, if we were going to setup wireless, is it possible to just connect an Access Point …

Member Avatar for chameleon
0
216
Member Avatar for chameleon

Hey everyone, building a new system here w/ a 3.4Ghz P4, ASRock 775i65Gv MoBo, 1Gig of Pc-3200 Ram, 450 Watt Rosewill Power Supply. My question is, why does the machine shut off 3 seconds after it turns on? I can press F2 to go into setup, and I can tell …

Member Avatar for belama
0
198
Member Avatar for chameleon

Greetings all, having this problem with a clients tape drive, I am suspecting that the drive is in fact shot and unusable, as I am receiving the same error message with 2 different tapes. But to be honest, i just dont know enough about tape backup, and Im sure using …

Member Avatar for DMR
0
229
Member Avatar for chameleon

I just built a new system P4 prescott 3.0 ghz, 1GB Kingston pc3200 Ram, 80 gb serial ata drive with an MSI 865PE Platinum motherboard and Aspire ATXB3KLW/350W case. For some reason, my front and rear usb ports do not function in windows. The additional 2 that I have in …

Member Avatar for Thong_Ispector
0
176
Member Avatar for chameleon

Hello, I am currently putting a system together, P4 prescott 3.0 ghz, 512MB Kingston pc3200 Ram, 80 gb serial ata drive with an ECS 865PE-A motherboard. When I first booted the machine it wasnt recognizing the serial HD, so I rebooted and went into the BIOS to enable the SATA …

Member Avatar for primesuspect
0
101