Protected mode reboots

Expand Post »

Why does my computer reboot after i set PE bit of cr0 or run lmsw? I have set all the code and data segments

Similar Threads

I can't boot into safe mode? in Troubleshooting Dead Machines
Help needed for a project concerning protected mode in Assembly
32 BIt Flat Real mode in C
32 BIt Flat Real mode in Community Introductions
Protected Mode Memory Map in C

sgk26p10p07

Reputation Points: 10

Solved Threads: 1

Newbie Poster

Offline

19 posts
since Oct 2007

Permalink

Nov 1st, 2007

Re: Protected mode reboots

There's a blurb over on WikiBooks about entering protected mode. I've never done it (nor do I care to) so I know nothing about it. However, if you are not doing all of the things listed there your pc will decide that something is horribly wrong and reboot.

Hope this helps.

Duoas

Featured Poster

Reputation Points: 1140

Solved Threads: 229

Postaholic

Offline

2,039 posts
since Oct 2007

This thread is more than three months old

No one has posted to this discussion for at least three months. Please let old threads die and do not reply to them unless you feel you have something new and valuable to contribute that absolutely must be added to make the discussion complete. Otherwise, please start a new thread in this forum instead.

Previous Thread in Assembly Forum Timeline: Sgdt,lgdt,ligdt,

Next Thread in Assembly Forum Timeline: LC-3 Maximum & Minimum

DaniWeb Message

Cancel Changes

User Name
Password