black screen.

[mmst]

okay so i tried to shut my computer down but it went to the blue screen (after you log out) and started updating this thing. well i was in a real hurry so i held the button on my cpu for a couple of seconds till it shut down. then the next time i tried to go on my computer it goes to the place where the safe mode and start up windows normally thing. i picked all of them even the last working configuration but it only goes to this black screen with the cruser. on safe mode it only has the safe mode words on the corners of the screen but it doesnt go to a new page...

[gerbil]

Safe mode, with those words in the corner should have a few icons, plus Start, Run..... and you can get TM with ctrl-alt-del.
Considering the date.. you may have blown up a M$ update or two.
Okay, on you way into safe mode did you try system restore?

[Bob_180_Bob]

System Restore from boot

1. Re-boot PC, after the single “Beep” tap F8 several times until the windows boot window appears.
2. Scroll to “Safe Mode” and press “Enter”
3. A window will open asking if you want to use “System Restore”
4. Select “Cancel” to enter “System Restore”
5. Ensure “Restore to an earlier time” is checked and click “Next”
6. Select an earlier date when your PC worked well. (Must be a highlighted date)
7. Click “Next”
8. Allow system restore and reboot.
9. Check to see if problem still exists.

Check Disk from Boot

1. Re-boot PC, after the single “Beep” tap F8 several times until the windows boot window appears.
2. Scroll to “Safe Mode with command prompt”
3. At command prompt Type “ chkdsk /f” (Note;- Space after chkdsk.)

To Repair Windows XP from your XP CD…..

1. Re-start PC with XP CD in drive (Have your serial number handy)
2. As your PC starts press “F12” for boot menu (Or what your PC may ask for)
3. Scroll to and select “boot from CD.”
4. At prompt “Press any key to boot from CD” Press “Any key”
5. In the Windows XP Setup window, Press “Enter” to set up windows XP, (Don’t worry, this is a repair only, not a fresh install.)
6. At next window, Press “F8” to accept license agreement
7. Wait until windows displays your current version of XP and asks “To repair the selected windows XP installation press R”
8. Press “R”
9. Enter serial number when prompted.
10. Wait for files to be copied (PC will indicate 39 mins, it will take a lot less.)
11. When asked to adjust Regional language options, click “Next” as it is still set.
12. PC will re-boot.
13. If you have AVG Free, copy serial number to a file as you will lose it on repair. After repair a window will pop up asking how you want to treat AVG, Click repair and when prompted enter serial number.
14. Check to see if problem still exists.