I had 2@256MB Dual Channel on my WXP SP1. Removed the two memory chips replaced by single channel 1 GB memory chip
The system at startup recognized the 1024 Memory BUT WXP w'not BOOT. Any suggestions. or explanations.
Do I have to reinstall WXP because I upgraded memory!!!!!!
arishy
0
Newbie Poster
Recommended Answers
Jump to PostNo RAM should not affect anything to do with windows as this is stored on your hard disk dirve. Check that you didn't knock any cables when changing the memory and also that the hard disk drive still appears in your BIOS. If it dosn't then you have probably knocked …
All 4 Replies
chris5126
26
Posting Pro in Training
arishy
0
Newbie Poster
chris5126
26
Posting Pro in Training
arishy
0
Newbie Poster
Be a part of the DaniWeb community
We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.