Member Avatar for Cyborggold

Setup is a follows:

DSL Modem ~> Netgear WGR614v9 ~> most computers (wifi) and one Cisco E1000 running DDWRT as an extender for a desktop to avoid buying another wifi card (no money).

The problem I am running into is everything works great on the 196.168.1.x protocol for a few hours to a few days, and then the Netgear switches itself to 10.0.0.1 ip and when I log in to the router I see a message that there was a conflict with the ISP and the address had to be changed.

Is there any way to prevent the Netgear from switching to the 10.0.0.x protocol? I cant get the E1000 to work on the 10.0.0.x protocol either or I would just run with that.

Thanks in advance for any help you can offer!

Edited by Cyborggold because: n/a
  • 2 Contributors
  • 2 Replies
  • 161 Views
  • 22 Hours Discussion Span
  • Latest Post Latest Post by Cyborggold

Recommended Answers

All 2 Replies

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.