No one has voted on any posts yet. Votes from other community members are used to determine a member's reputation amongst their peers.
Is there a product that will allow me to extend a PCIe Gen2 bus over fiber to a 4 slot expansion backplane? HBA in PCIe BUS>fiber> 4 Slot PCIe expansion backplane. I dont need the distance, but the convenience of a bulkhead fiber transition connection. thanks for any thoughts |
|
For an IP conversation that is passed through 2 routers.... and packets are captured at the output of each router at the ports the IP conversation is routed to..... would each side of the router packet capture carry the same packets or conversation packets with the exception being that the … |
|
Does RSVP determine what incremental delay to specify for each router so a total end to end delay is not exceeded? Or as an example, if the RSVP protocol determined there are 5 routers in a path and its end to end (Sender to Receiver) delay requirement is 500ms would … |
|
How can I ping point to point, or ethernet to ethernet when there is no IP address assigned? Is that possible? I tried using a MAC address with Ping but that did not work. In this case its a PC to a ethernet to 100BaseF (fiber) conversion and I want … |
|
I'm putting together a simple animation using Powerpoint to show how data would be routed in a small network under various conditions including link failures. Is there a software application that will simulate network performance and present in a graphical way like I'm trying to do with powerpoint? Hopefully something … |
|
I have a 100BaseT Ethernet Router to Ethernet Router link over several miles of fiber using TCP/IP with fixed IP addresses. Nothing in between except fiber and electrical to optical conversion. What test equipment is recommended to measure Bit Error Rate from Ethernet port on one end to Ethernet Port … |
|
How can one configure a LAN to have redundant links to a single NIC or MAC address? This would be called fault tolerant so that if one link failed the other link would still provide data. The flow would be 2 - 100BaseT links from a server to router/switch for … |