RIP OFF! get a soldering iron and you can make XBOX/PS2/GC/USB Connectors for nothing!! for example the XBOX to USB involves chopping the xbox cable and usb cable and soldering all but one wire. If you get some wire and some USB connectors its an easy job. I know someone who made my bothers GC and P2 one so if I find out i will post the details up
BHP I would appreciate if you could get me the details for that. I have a friend that is very handy with wires and soldering, and loves emulators as well
which one? For the XBOX as i said its just a case of cutting and joining wires. All you need then is the drivers. I will have to check for the PS2 one as i dont use it much (i prefer mouse for FPS) and i dont fancy removing the mountain of electrical tape on my bros GC adaptor.... i will have a look and post ASAP
ill have to look at a schematic for it. Someone else made my / my bros PS2 connector and only he knows what driver is needed. If anyone wants i can make what i have in my usb slot --> a 3 way adaptor! all it is is wire, sheathing and heatshrink. Add to that an xbox/ps2/gc/usb connector and its done!
Cut usb and cut xbox wires. xbox wires should be cut after the connector to the console (ie you cut the small wire not the controller main wire). For each coloured wire twist the cut ends XBOX cable back together and also twist it with another wire and solder. This way you have an XBOX 2 Console OR USB connector (ie one end = controller, other two ends = xbox and usb). Cover the join with heatshrink or electrical tape. The exception is the YELLOW WIRE. This has no need to be connected to the USB end.
When you have the part search google for the drivers as i cannot remember where I found them :( hope this is useful to anyone!
