1.11M Members

Front Panel Audio

 
0
 

The wires on my case are listed as follows
Mic In , Mic Bias , Ground , Spk Out R , Spk OutL ,
Return R , Return L

While the motherboard is worded as follows
Mic , Mic Power , Aud-Out R , Aud-Out L , GND , +5VA , GND (again) , Backout-R , Backout-L

Please help me match these up. Thanks.

 
0
 

The wires on my case are listed as follows
Mic In , Mic Bias , Ground , Spk Out R , Spk OutL ,
Return R , Return L

While the motherboard is worded as follows
Mic , Mic Power , Aud-Out R , Aud-Out L , GND , +5VA , GND (again) , Backout-R , Backout-L

Please help me match these up. Thanks.

how do i match these

 
0
 

wires on my case are listed as follows
Mic In , Mic Bias , Ground , Spk Out R , Spk OutL ,
Return R , Return L

While the motherboard is worded as follows
Mic , Mic Power , Aud-Out R , Aud-Out L , GND , +5VA , GND (again) , Backout-R , Backout-L

Mic In = Mic
Mic Bias = Mic Power
Spk Out R=Aud-Out R
Spk OutL =Aud-Out L
There are a few, I would look at the motherboard spec's for the rest of the info, you didn't tell us what it was

 
0
 

asus pinout to new case not responsable for others

pin1 mic2 = mic in
pin3 micpwr = micbias
pin5 lineout_r = r-speaker out
pin7 nc
pin9 lineout_l = l-speaker out

pin2 agnd = ground
pin4 +5va
pin6 bline_out_r =return r
pin8 empty no pin
pin10 bline_out_L =return L

good luck

 
0
 

Ok I have a question. I bought a case and trying to hook up front panel audio but the case connections are different from what mobo has. Connects are

Case:
Return R
Return L
Spkout R
Spkout L
Mic In
Mic Bias
Grnd

Mobo Connections:
Port1L
Port1R
Port2R
Port2L
Sence_Send
Ground
Presence #
Sence1_Ret
Sence2_Ret

Which wires go where I am lost. Thank you again for the help. The board is a Intel D915PGN. Thank you again

You
This article has been dead for over six months: Start a new discussion instead
Post:
Start New Discussion
Tags Related to this Article