how can i use telnet command for my pcs and router.
i am using winxpsp2
ameen_zaman
0
Newbie Poster
Recommended Answers
Jump to PostTo open Telnet
Press Start > Run and type cmd then click ok.
Type telnet then press enter
Jump to Posttelnet should be enabled on the target host. if it is, just run "telnet targethost/targetIP"
if you want to connect to a specific port, just add it's number after the targethost.
All 7 Replies
Michael_Knight
10
Posting Whiz in Training
DimaYasny
180
Godmode enabled
Team Colleague
Featured Poster
ameen_zaman
0
Newbie Poster
DimaYasny
180
Godmode enabled
Team Colleague
Featured Poster
jbennet
1,618
Most Valuable Poster
Team Colleague
Featured Poster
ameen_zaman
0
Newbie Poster
bobbyraw
16
Nearly a Posting Virtuoso
Be a part of the DaniWeb community
We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.