-1

hello,
i have a problem in my assembly program.
i have a problem with open and create files.
in my program i always open and create a new files ,but after 5-6 open\create ,the program stop working.
i think the problem is that my file handle is not available (after error ,ax=0004).
how it can be? 5-6 time its going very well but after thar their is an error?

Moderator's Note

Since the code seemed to break the forum formatting, it has been removed from the post and made into an attachment instead. Please find the code attached in the file 'code.txt'.

Votes + Comments
Review before posting, this is awful to look at
3
Contributors
3
Replies
4
Views
9 Years
Discussion Span
Last Post by Salem
0

Great, perhaps next time you could read the forum rules of posting formatted code before dumping such a huge mess on a message board.

0

Phew! Next time make sure you attach your code instead of dumping the entire 1.6K line thing on the message boards.

0

> i think the problem is that my file handle is not available (after error ,ax=0004).
According to THIS, the error code means "too many files open".

So I'm going to guess that not all your open's are matched with close's. As such you leak handles then run out of them.

Get the whole Ralph Brown list if you ever want to make serious use of such low-level programming.

This topic has been dead for over six months. Start a new discussion instead.
Have something to contribute to this discussion? Please be thoughtful, detailed and courteous, and be sure to adhere to our posting rules.