Distance Programming Problem
Hello,
Hi, I am using LabVIEW to program. We recently came up with a new idea for our Autonomous program, and to do that I need it to drive certain distances and turn a certain degree.
Is there a way to do this without any special sensors on it?
And how do i measure in this "encoders"? Because I put the number 1 in for the fixed distance and it goes nowhere but i put the number 10 in and it goes a good 20 or so feet. I can't figure out how to do... for example... 42 inches then turn 45 degrees.
Any help on how to go about doing this?
Thanks for the help,
Jacob