I just installed a western digital slave drive in my pc.
When I reboot the found new hardware wizard pops up.
I have formatted the slave drive and I still get the wizard.
I have checked the Master/Slave connections on the drives and they are correct.
Does anyone have an answer?
dragonr
0
Newbie Poster
mechbas
-5
Posting Pro
hmmm, you didn't mention how or where you formatted. the prob. could still be a bad Y cable (the cable itself could be bad) connection and/or incorrect jumper settings on the master and slave drive.
dragonr
0
Newbie Poster
I formatted the drive in computer management > disk management.
I will check the master/slave jumpers again and if it does not work
set the jumpers to Cable Select later on tonight.
Be a part of the DaniWeb community
We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.