Can anyone please help me? I have a computer with athlon processor and 1 and a half Gig ram, two hard discs. It was a very expensive machine that in a few months after I bought it needed a new main board because the original was of poor quality and I was scamed by the store I bought it from.
A while ago, when I turn it on the lights turn on, the sound beeps but suddenly goes down. It does it several times in a row and finally dies completely. Is inside a box with six fans so I don't think its over heating. I took it to the server and the technics on other store told me that one of the hard discs was about to collapse and i got a new one.
I brought it home, worked for a few days and the problem seems to have come back.
Can anyone of you help me guys?
K

Dani AI

Generated

A practical checklist for a machine that powers up briefly, beeps, then dies repeatedly. As suggested, capture whatever POST/beep pattern you hear (use a phone video or audio so you can replay and count short vs long beeps). Also follow ’s minimization idea: isolate the fault by testing parts one at a time, but do it with a measured sequence below.

  1. Quick, safe bench steps
  • Disconnect all nonessential peripherals and drives. Boot with just motherboard + PSU + CPU + one known-good RAM stick (and video if needed).
  • Try one RAM stick in different slots. Swap the RAM with a known-good stick if available.
  • If the machine still fails immediately, try a known-good PSU or a PSU tester; measure the 12V, 5V and 3.3V rails with a multimeter if comfortable doing so.
  1. Capture POST details and use tools
  • Record the sound pattern and any motherboard LEDs or Q-codes. Look up the motherboard/BIOS vendor in the manual to map the pattern to a failure area.
  • If available, use a POST diagnostic card or an external speaker to get a clearer code.
  1. Visual and mechanical checks
  • Inspect the board for bulging/leaking capacitors, scorch marks, loose power connectors or bent CPU-socket pins.
  • Remove the motherboard from the case and try on a non-conductive surface to rule out a short to the standoffs or front-panel wiring.
  • Test by shorting the power-switch pins briefly with a screwdriver to rule out a stuck front-panel switch.

Cautions and next steps

  • Work grounded and power off when reseating parts. If tests point to the PSU or VRM but you can’t swap parts yourself, get a shop to confirm. Document each change so you can trace what fixed—or failed to fix—the fault.

Recommended Answers

All 3 Replies

those beeps are a code to what is wrong based upon the bios chipset...

Usually in a sequence of three or four groups...

Usually 1,1,1 is ram etc...

Did you ever check the cmos to see the temp of the cpu?

those beeps are a code to what is wrong based upon the bios chipset...

Usually in a sequence of three or four groups...

Usually 1,1,1 is ram etc...

Did you ever check the cmos to see the temp of the cpu?

Thanks Inspector
I found your observation very clever and i must think about it although this computer has a fancy pannel that is supposed to control the temperature of all those fans inside and the devices they are cooling. Since the first day i got it it will make several beeps when i turn it on but in fact i never payed really attention to its sequence. Maybe you are right and it is turning of because of the temperature is getting to a critical point. but then.... just on the moment i turn it on?
K

It might be one of the components you haven't replaced yet. my technique is to start the machine without one of the components, one by one. If booting persists to fail it might be the PSU or CPU. Good luck.

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.