In my Notebook HP COMPAQ 6910p
When i power on the device.. the laptop gets on and i can see nothing but a black screen (seen like when turned off) with a faster processor fan speed..

The same happened twice before and itself randomly got correct when i kept it unused for few days..
But this time no change has occured..

Any solution pls....???

Dani AI

Generated

Brief, practical checklist for the HP Compaq 6910p black-screen symptom, building on 's report and the suggestions from and .

Start with these safe, low-cost checks:

  • Perform a power drain: unplug AC, remove the main battery, then hold the power button 15-30 seconds to clear residual charge. Reconnect AC (leave battery out) and attempt boot.
  • Test external video exactly as suggested by : connect a VGA/CRT/HDMI monitor and use the display-toggle key (the key with the monitor icon) to force external output. If the external shows BIOS/desktop while the laptop panel is black, the fault is very likely the LCD panel, the panel backlight/inverter, or the LVDS cable.
  • Check for a faint image on the internal screen by angling a strong light source across it. A faint picture with no backlight points to inverter/backlight failure rather than a GPU/POST problem.
  • Reseat and test memory modules one at a time. Faulty or poorly-seated RAM commonly prevents any display or POST.
  • Replace the onboard RTC/CMOS coin cell as suggested and reset BIOS defaults if accessible. Confirm the exact cell type before buying.

If none of the above produce signs of POST (beeps, LED patterns, or external video), the failure may be board-level (power circuitry or chipset). Given the 6910p's age, weigh repair costs against replacement or salvaging parts. When opening the chassis, always disconnect all power, remove the battery, and take ESD precautions; if unfamiliar with laptop teardown, consult a repair shop.

Recommended Answers

All 2 Replies

Is this that 2007 model? It's well past it's time. That said I do know some that found it for 120 bucks on a Woot sale. Try the usual. A new CMOS battery and hope.

Does it have a VGA port for an external monitor. Plug in a monitor and boot it just to be sure you have no LCD display. If the external also fails, then you have more serious issues. It's probably not worth repairing a laptop that old.

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.