amd 1800+ with 512 ddram 2100 with this processor

i plan on upgrading the ram and processor i just want to know if this stuff will work with this motherboard as a temporary thing until the upgrade.

Dani AI

Generated

Short answer: very likely yes. If the Biostar board in the listing is a Socket A (462) board, an Athlon XP 1800+ will physically fit and a 512MB PC2100 (DDR266) DIMM of the correct type should work as a temporary setup. There are a few common checks and gotchas to avoid hassles.

What to check first

  • Confirm the board is Socket A and accepts Athlon XP CPUs by checking the motherboard CPU support list in the manual or vendor support page (as suggested).
  • Make sure the memory is 184‑pin DDR DIMM, unbuffered and non‑ECC. PC2100 modules are the right family; faster DDR sticks will usually run at the board's top supported speed.
  • Verify the BIOS version supports the specific 1800+ you have. If the CPU came later than the board, a BIOS update may be required. Some older boards require a working older CPU to flash the BIOS, so plan ahead.

Quick install and troubleshooting tips

  • Install one stick of RAM in the primary DIMM slot, fit the CPU with a correct Socket A heatsink and fan, connect the CPU fan header, then try to POST.
  • If it does not POST: reseat components, clear CMOS, listen for beep codes, try a different RAM stick/slot. If POST fails and the BIOS is too old, update BIOS per manufacturer instructions (or borrow a compatible CPU to boot while flashing).

As noted, there is no obvious reason it would not work, but confirm the memory type and BIOS CPU support before relying on it for a short-term build.

Recommended Answers

All 2 Replies

looks like it will ,download the motherboard manual here .

I don't see why it wouldn't...

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.