Member Avatar for Muizz2411

Anyone please, help my acer aspire one stuck at window xp logo loading. I try everthing in F8 button, it didn't work, even in safe mode stuck at 'window starting up'. Please anyone, help me, i don't want waste my money to fix this (T-T)

  • 6 Contributors
  • 8 Replies
  • 728 Views
  • 2 Years Discussion Span
  • Latest Post Latest Post by youssefmanm

Dani AI

Generated

Several useful suggestions are already in the thread — (drive-out testing), (repair/restore options) and (recovery partition hint) — so the short plan below focuses on non‑destructive diagnostics that preserve data and separate hardware faults from a corrupted Windows install.

  • Try a bootable live USB (Ubuntu or a rescue PE such as Hiren’s) so the machine runs without using the internal disk. If the laptop boots a live desktop, the internal drive/Windows install is the likely culprit; if it hangs before the live media, the problem is firmware/hardware. / . ()

  • Run a full RAM test from boot (MemTest86). Bad memory often causes machines to stop during the “Windows is starting up” phase even for Safe Mode. Create a MemTest86 USB and run several passes. (See the MemTest86 instructions overview.) (corsair.com)

  • If the drive tested OK on another PC (as reported), run a dedicated drive diagnostic (SeaTools or the drive maker’s bootable tool) against the same disk image to check SMART and surface errors. If the drive is healthy but any HDD attached makes the laptop hang (as described), suspect the laptop’s SATA/power interface or logic board. Seagate SeaTools Bootable. (seagate.com)

  • Physically inspect and reseat the drive and its connector (remove battery/power first). Netbooks often have a small SATA connector or flex cable that can be misaligned or corroded; reseating is a low‑cost test. See an Aspire One HDD removal guide for reference. (ifixit.com)

Also check BIOS settings (enter with F2): verify SATA mode (try switching between AHCI and Compatibility/IDE if available) and confirm any D2D recovery setting is enabled if recovery is needed — those options vary by model. If the drive and RAM pass diagnostics but the laptop still hangs with any drive connected, the SATA controller or power delivery on the motherboard is the most likely cause; at that stage, board repair or replacement is the reasonable next step. For data safety, copy important files off the drive using a live USB before any repair/format. (community.acer.com)

If the goal is to save files first: boot a live USB, mount the internal disk and copy the user folders to an external drive; only then attempt repairs that overwrite the disk.

Recommended Answers

All 8 Replies

Member Avatar for Rik_

If you have the equipment, you need to take the hard drive out of your laptop, connect it to a usb adapter and test it with another computer.

Member Avatar for RTFMID10T

Anyone please, help my acer aspire one stuck at window xp logo loading. I try everthing in F8 button, it didn't work, even in safe mode stuck at 'window starting up'. Please anyone, help me, i don't want waste my money to fix this (T-T)

under safe mode f8 did you choose use last known good configuration? windows does this from updates from time to time. if not i'll tell you the other way to fix it easy with the xp cd.

Member Avatar for Muizz2411

under safe mode f8 did you choose use last known good configuration? windows does this from updates from time to time. if not i'll tell you the other way to fix it easy with the xp cd.

umm can i reformat this laptop if possible since safe mode & last known didnt work? btw my laptop doesnt have place to put cd

Member Avatar for RTFMID10T

you can reformat it, but your going to lose any files you may want to keep. the other option you can try is to boot from the xp cd and go as if you are trying to install a fresh copy of xp, but when you get to the screen where you choose the drive to install a new copy you should get an option to Repair and will reload all windows files in the windows directory to boot and then you can backup all your documents. Then i would advise to make a clean install and format to clean up any other issues this has created. Genereally after a repair in XP the system does run a little sluggish in this state, but makes it possible to save data.

Member Avatar for Muizz2411

@Muizz2411 you can reformat it, but your going to lose any files you may want to keep. the other option you can try is to boot from the xp cd and go as if you are trying to install a fresh copy of xp, but when you get to the screen where you choose the drive to install a new copy you should get an option to Repair and will reload all windows files in the windows directory to boot and then you can backup all your documents. Then i would advise to make a clean install and format to clean up any other issues this has created. Genereally after a repair in XP the system does run a little sluggish in this state, but makes it possible to save data.

well worth to try, k i try your advise & i will post here if it work :D

Member Avatar for caperjack

aspire one should have a recovery partition to load netbook back to factory settings .i think its ,"alt +f10" on bootup ,did one just about 2 mnts ago and cant remember what f key exactly it was to get the option

Edited by caperjack because: n/a
Member Avatar for vxhyda

hello guys. i need your help. ive been trying to figure out the problem of my aspire 4810t. i tried to pull out my hard drive and plugged it on other laptop and it seems to be working well. but when i plugged any hardrive into my laptop it just stuck with logo loading. can u tell the problem?

Member Avatar for youssefmanm

me to have this problem

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.