Member Avatar for ziggy895

Can any one help me open the case on my Gateway Solo 2150?
Thanks,

  • 3 Contributors
  • 2 Replies
  • 37 Views
  • 15 Hours Discussion Span
  • Latest Post Latest Post by dcc

Dani AI

Generated

Pics would help, as asked, but here is the usual take-apart sequence for a Gateway Solo 2150 (Solo 21xx series) so you can get the case open safely. No sawzalls needed, .

  • Power down, unplug AC, remove the battery, and eject any PCMCIA cards. Press and hold the power button 10 seconds to discharge.
  • Pull the HDD and optical/floppy modules. On this era of Gateway, there is often a single retaining screw for each module accessible from the bottom or side; slide them out so they are not in the way.
  • Remove all bottom-case screws. Check inside the battery bay, HDD/ODD bays, and under any small rubber plugs; Gateway liked to hide one or two. Keep screws grouped by location.
  • Open the lid fully. Pry up the hinge cover/keyboard bezel (the narrow plastic strip above the keyboard) starting at the right hinge with a plastic spudger. If it will not lift, you likely missed a screw near a hinge or in the rear I/O edge.
  • With the hinge cover off, remove the small screws securing the keyboard along the top edge. Slide the keyboard slightly toward the screen to free the front tabs, then lift and disconnect the flat ribbon cable.
  • Disconnect the touchpad ribbon cable. Remove any visible top-side screws holding the palmrest, plus the remaining front-half screws from the bottom.
  • Lift the palmrest/top cover gently, releasing plastic clips along the front edge. Do not force it; if it resists, you missed a screw.
  • Reassembly is the reverse. Route ribbons flat and straight to avoid pinching.

If you only need RAM or the HDD, you may not need to open the full case; those are usually behind bottom access panels or side caddies. If you get stuck on a specific step (hinge cover, for example), post a close-up and we can point to the latch points.

Recommended Answers

All 2 Replies

Member Avatar for jbennet

Provide some pics

Member Avatar for dcc

Sawzall!

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.