Comuter reboots itself 2-3 times each time at start up(at booting time) ,after giving a blue screen.
Checked the error with blue screen viewer and it says problem with Hardware abstract layer,none page fault in none page area.
Really annoing ,each time i start,need to wait this circle to pass.Any ides?Thanks
aluhnev 0
Junior Poster in Training
Recommended Answers
Jump to PostHave you tried running the recovery disk/partition?
All 3 Replies
rubberman 1,355
Nearly a Posting Virtuoso Featured Poster
Have you tried running the recovery disk/partition?
aluhnev 0
Junior Poster in Training
I tried the installation disk,to fix problems with start up,but it didn't find any problem
rubberman 1,355
Nearly a Posting Virtuoso Featured Poster
You might want to run the full disk check utility (requires rebooting) to see if there are bad sectors on the disk. If the DLL is stored on a bad sector that is having read problems, that could explain this issue.
Be a part of the DaniWeb community
We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.