Member Avatar for ladypunx

Every time it boots and I get into the PhoenixBIOS setup and run the diagnostics, it says that 1-07 fail. If I try and let it boot up it will ask if to go to the safe mode or normal mode command. Each time it will go to a blue screen and blink so fast that you can't read it then reboot again. I'm not quite sure on why it's doing this.

  • 2 Contributors
  • 3 Replies
  • 127 Views
  • 7 Hours Discussion Span
  • Latest Post Latest Post by caperjack

Dani AI

Generated

— PhoenixBIOS reporting "1-07 fail" plus the fast BSOD/reboot loop strongly points at a failing hard drive; is on the right track. That diagnostic is the BIOS hard-drive self-test (SMART/read/write check) failing, which will cause Windows to crash when the OS loses reliable access to the boot disk. The goal now is to confirm the drive state, recover important data if needed, then replace or repair.

Practical next steps to confirm:

  • Enter BIOS and verify whether the drive is listed (model and capacity). If the drive is not detected at all, that’s a hardware-level issue.
  • Power completely down, remove AC/battery, and reseat the 2.5" drive (laptop connectors can work loose). Power up and re-check BIOS.
  • Boot from external media (Windows install DVD/USB or a Linux live USB). If the live system sees the disk, run a SMART check and surface tests with a manufacturer tool (SeaTools, WD Data Lifeguard, etc.). If you only get I/O errors or the disk is not visible, treat it as failed.

Data-recovery and repair guidance:

  • If data is important and the disk still reads, immediately image the drive to another disk before attempting fixes. On Windows use recovery console tools or chkdsk /r from repair mode; on Linux use cloning/imaging tools (ddrescue) to capture as much as possible.
  • If the drive clicks, makes strange noises, or is not readable, stop attempts and consider a professional data-recovery service.

If tests confirm failure, replace the drive with a compatible 2.5" SATA HDD or SSD and reinstall the OS. If a new drive still isn’t detected or BIOS keeps reporting errors, suspect motherboard/SATA-controller trouble and get hardware service. To read the Blue Screen error instead of a quick reboot, press F8 at boot and choose “Disable automatic restart on system failure.”

Recommended Answers

All 3 Replies

Member Avatar for caperjack

many thanks!

your welcome, good luck

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.