Member Avatar for xjtk02x

I have a Toshiba Satellite L305D-S59222 when i try and get into bios by clicking the F2 button it freezes and wont go into it, and when i don't try to get into bios it tries to boot from a network, I can't change the boot because i can't get into bios and i can't reset the bios by the battery and i don't see a jumper that i can reset bios with either. I don't have the money to call tech support or i would have done that already. How do i reset the bios on a Toshiba Satellite L305D-S59222

  • 2 Contributors
  • 3 Replies
  • 121 Views
  • 11 Hours Discussion Span
  • Latest Post Latest Post by xjtk02x

Dani AI

Generated

As described, the machine hangs when trying to enter BIOS (F2) and otherwise falls to a network/PXE boot. That pattern usually points to one of three root causes: a storage device or other peripheral that fails during early hardware init, a bad memory module, or a corrupted/locked firmware state. 's suggestion about service-only is not strictly true — many of these faults can be diagnosed and repaired by an experienced user or independent shop — but proceed carefully.

Quick, non-destructive checks to try first:

  • Power-drain the system: unplug AC, remove the main battery, then hold the power button 20–30 seconds before powering on.
  • Disconnect all external USB devices and any Ethernet cable and try booting again.
  • Reseat RAM sticks (try one stick in each slot) and fully reseat the hard drive/SSD. If the drive is removable, try powering up with the drive removed — a failing drive can cause BIOS to hang and force PXE.
  • Try alternate boot keys (tap Esc, F12, F1) repeatedly right after power-on in case timing is the issue.

If those fail, the next safe step is to check/reset the RTC/CMOS. On this model that typically requires accessing the coin-cell or a dedicated clear header inside the chassis. This can mean removing panels or the keyboard; document each screw and connector and take photos. Disconnect power and observe ESD precautions. Remove the coin cell or short the proper pads for a minute, then reassemble and test.

If BIOS still freezes, the fault is likely deeper (firmware corruption or failing board) and flashing a BIOS or replacing the motherboard becomes risky. At that point consider data recovery by connecting the drive to another PC and get a local repair shop to perform a professional BIOS reflash or board repair rather than risking a bad flash.

Recommended Answers

All 3 Replies

Member Avatar for finito

Your screwed m8, They have a strict Toshiba Service only policy.
Only Toshiba can do it for you.

Member Avatar for finito

Hmm, Some googling showed me the answer

Edited by finito because: n/a
Member Avatar for xjtk02x

lol well i tried it and it's not working =/ i'm either the most unluckiest when it comes to bios or i'm just screwed.

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.