i wanted to add another hard drive to my computer (200 gb hard drive being added) so i tried to install it, after i did that i tried and start up my computer but all i would get is a black screen (the little light beside the monitor button would flash orange) so i took the drive out and tried again and the same thing happen. does anyone know what the problrm might be and how i might be able to fix it?
dabomb41
0
Newbie Poster
Recommended Answers
Jump to PostHow are you connecting the drive? if its on 1 cable (for both drives) make sure the jumper settings on the drives are set to master and slave
Check your BIOS settings too.
All 3 Replies
AcornDomains
0
Newbie Poster
How are you connecting the drive? if its on 1 cable (for both drives) make sure the jumper settings on the drives are set to master and slave
Check your BIOS settings too.
tjmkkishore
0
Newbie Poster
Also check the IDE cable connected and master / slave options...
dabomb41
0
Newbie Poster
i think its my video card anyways thanks for your replys
Be a part of the DaniWeb community
We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.