Hey, when i'm wiring the case to this bored my power led wont fit. On the board the power led pins are by eachother and on my power led connector there's three slots and an empty slot in the middle so therefore it wont fit. What can i do?
UNKNOWN_MEMBER
0
Light Poster
Recommended Answers
Jump to PostGet a pin. Push down on the little metal tag you see on the plug to allow the pin on one of the wires to be pulled back out of the plug, and then push it into the other hole so the two wires are side by side.
If …
All 3 Replies
Catweazle
140
Grandad
Team Colleague
Get a pin. Push down on the little metal tag you see on the plug to allow the pin on one of the wires to be pulled back out of the plug, and then push it into the other hole so the two wires are side by side.
If the spacing of the pins on the motherboard header are too close for a 3 pin width plug to be actually used, then remove a plug from some old scrap component or lead, pull both wires out of the 3 pin plug and then fit them to a 2 pin plug.
It's quite easy to remove the wires ;)
UNKNOWN_MEMBER
0
Light Poster
alright cool, the white wires are ground and colored are positive right?
Catweazle
140
Grandad
Team Colleague
Usually, but not always. You're talking only two wires. If it don't work one way round, then turn the blasted plug around! :D
Be a part of the DaniWeb community
We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.