Member Avatar for epicasian

Hey everyone,
My problem is that my graphics card is getting extremely hot (112c). I took it out to see if there was any dust or other particles on it, but there was not. However, I did try to spin the fan, and it seem like it had some resistance to it. Does anyone know how I could get that resistance to be no more? If I need to add any other info, I will gladly do so.

Thanks in advance =D

Edited by epicasian because: n/a
  • 3 Contributors
  • 2 Replies
  • 131 Views
  • 13 Hours Discussion Span
  • Latest Post Latest Post by caperjack

Dani AI

Generated

reported a GPU reading of 112C and a fan that offered noticeable resistance when spun. That temp is high enough to risk permanent damage, so stop using the card until you confirm what is actually overheating. First verify the temperature with a second tool (for example, a different GPU monitor) to make sure the sensor reading is accurate and that the core — not some auxiliary diode — is what’s at 112C.

Follow a short diagnostic sequence before taking anything apart:

  • With power off, inspect the fan area for cable contact, warped blades, or a foreign object trapped in the shroud.
  • With the machine powered but idle, watch the fan header: does the fan try to spin when the card heats up? If available, carefully swap the fan connector to a known good header or use a known-good case fan to see if the GPU cooler gets power.
  • If the fan receives power but barely moves, the failure is mechanical. If it never gets power, trace the connector and PCB traces for damage. Take photos before disconnecting anything.

If disassembly is needed, document every screw and bracket, use an ESD strap, and clean/inspect the heatsink-to-die contact. Replacing dried thermal compound and reseating the cooler often makes a big difference. If the card is still under warranty, contact the vendor before opening it (RMA is often the safest route).

As interim cooling, increase case airflow or point a strong case fan at the card to prevent further damage while you diagnose. As and pointed out, this is primarily a hardware problem; the steps above focus on confirming whether the issue is electrical, mechanical, or thermal so the right repair path (warranty service or shop repair) can be chosen.

Recommended Answers

All 2 Replies

Member Avatar for Rik_

The fan has a bearing, the bearing is most likely dry of grease.
Taking it apart and greasing it is a fiddly and time consuming job. You may be better off just buying a new fan for it.

Member Avatar for caperjack

i have loosened a few by just simply peeling back the little round sticker on the center of the fan and using a 3in1 type oil,no need to take it apart ,for me in some cases anyway

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.