Member Avatar for LiTos456

Hey, remember me? I'm back with no signal! *dun dun dun dun* *dramatic music*

I rebuilt my computer... Heres what I've changed:

New Motherboard: Asus P5N-E Sli
New Video Card: e-GeForce 8600GT
New Processor: Intel Core 2 Duo E6550
New Ram: 1 GB DDR2 Ram (1 chip, but I'll probably get another gig).


Problem is simple: I connect everything, everything should work fine, but - no signal on the monitor. But I think this is solvable...right? Please I need help. Badly.

  • 3 Contributors
  • 4 Replies
  • 132 Views
  • 2 Weeks Discussion Span
  • Latest Post Latest Post by xzqta

Dani AI

Generated

This thread shows a common "no signal" symptom. later posted "solved nvm" without saying how, and rightly suggested confirming the monitor; posted a similar problem. The short checklist below covers the highest-yield checks and isolation steps used to find the fault quickly.

Start with the display side: confirm the monitor has power and the correct input selected, and try a different cable and port. Test the monitor on a known-good system and try a different monitor on the suspect PC. Be aware of adapter limits (passive DVI-to-VGA needs DVI‑I; other conversions require active adapters).

Move to the system itself (power down and unplug before handling components). Reseat the graphics card and RAM, ensure any required PCIe power connectors are plugged, and remove all nonessential cards and drives to create a minimal-boot configuration (CPU + one RAM stick + GPU or onboard video). Clear CMOS (jumper or battery) and check motherboard POST/beep codes or onboard debug LEDs; consult the board manual for meanings.

If the problem persists, isolate components by substitution: try the GPU in another PC, try a known-good GPU in the motherboard, or use onboard video if available. Verify the power supply can deliver required rails or swap in a different PSU. Bench-test the board outside the case to rule out shorts. After these steps, a persistent "no signal" usually indicates a failed graphics card, power issue, or motherboard fault and typically requires a component swap or professional diagnostics.

Recommended Answers

All 4 Replies

Member Avatar for LiTos456

bump

Member Avatar for webbo

i'm just gonna trough this crazy question out there, so here goes;

you have checked that the monitor works right?

i mean you've practically rebuilt your pc!!!

Member Avatar for LiTos456

I did...its solved nvm

Member Avatar for xzqta

hi my monitor shows no signal . i do not know whats wrong with it.please any help me!!

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.