Member Avatar for RiceKernel

I'm going to receive my new motherboard soon and I was just wondering where the power switch goes in the motherboard.

Could someone indicate me where is the appropriate place to plug it in , in this mother board :
http://www.newegg.ca/Product/ImageGallery.aspx?CurImage=13-128-449-Z03&SpinSet=13-128-449-RS&ISList=13-128-449-Z01%2c13-128-449-Z02%2c13-128-449-Z03%2c13-128-449-Z04%2c13-128-449-Z05&S7ImageFlag=1&Item=N82E16813128449&Depa=0&WaterMark=1&Description=GIGABYTE%20GA-G41M-Combo%20LGA%20775%20Intel%20G41%20Micro%20ATX%20Intel%20Motherboard

It would be greatly appreciated if you could edit it in paint and make a rectangle on the appropriate place.

Thank you!

  • 2 Contributors
  • 2 Replies
  • 224 Views
  • 14 Hours Discussion Span
  • Latest Post Latest Post by jak0b

Dani AI

Generated

asked where the power switch plugs in; correctly pointed to the motherboard front‑panel header. The original followup about a single bundled plug is common — cases sometimes deliver all front‑panel leads in one molded block. Practical options and safe steps follow for separating or working with that bundle.

  1. Safety first: the system should be powered off, unplugged from mains, and placed on a nonconductive surface before handling front‑panel leads. Static precautions are recommended.
  2. Identify each lead by printed labels on the wires (common markings: PWR_SW, RESET, HDD_LED, PLED). If labels are missing, consult the case or motherboard manual to map functions.
  3. Inspect the bundled plastic block for tiny release tabs above each metal contact. A thin pick or small flat screwdriver can be used to depress the metal retainer inside the housing while gently pulling the insulated terminal out. Pull the terminal/housing, not the bare conductor. Work one contact at a time.
  4. If the contacts are permanently molded and do not release, the block may be nonserviceable. If the block matches the board’s pin count and layout, leaving it intact is acceptable. Otherwise, cutting and reterminating into individual 2‑pin housings with proper crimp pins and a crimp tool is an option, but it is irreversible and should be a last resort.

Switches (power/reset) are not polarized; LED plugs are. The positive LED lead is often marked or colored; swapping the two LED pins corrects a nonlit LED. Avoid casually shorting live header pins to test the board unless experienced and taking proper safety steps. Useful tools: precision screwdriver or pick, tweezers, small crimp tool, and replacement 2‑pin housings. Following ’s advice to check the manual first will prevent miswiring and damage.

Recommended Answers

All 2 Replies

Member Avatar for RiceKernel

Ok , forget my previous question. Now I have another problem... In the front panel, normally the switches and leds are seperated from each other but mine, Power Switch, Reset Switch and the leds are all BUNDLED together into ONE connector... How can I seperate them?

Member Avatar for jak0b

If you look at the picture (the link) in the lower left corner, You have a F-panel connector.
This is what you are looking for - check the manual to see if all the wires are in the right places before plugging it in though. :)

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.