Member Avatar for bondi007

This happened to me every time i put a floppy in the drive new or used the computer freezes and wont let me write to the floppy i tried moving the little tag at the bottom of the floppy it doest work ether i try formatting a floppy in windows (it crashes) i try formatting it in command prompt i get the blue screen of death

i hope someone can help me :-|
cheers

  • 2 Contributors
  • 2 Replies
  • 51 Views
  • 22 Hours Discussion Span
  • Latest Post Latest Post by bondi007

Dani AI

Generated

Given that any access to A: freezes or BSODs, this is almost always the floppy path itself (drive, 34‑pin cable, motherboard controller, or a low‑level filter/driver), not the disks or the write‑protect tab. The tab would just give a write‑protected error, not a crash. is probably right that the drive is bad, but a few quick checks can save you a trip.

Try this, in order:

  • BIOS: Confirm Drive A is set to 1.44 MB, 3.5". If it is disabled or mis‑set, fix that first.
  • Cable and orientation: Power off, unplug power, ground yourself. Reseat the 34‑pin ribbon at both ends. The red stripe must go to pin 1 on the drive and on the motherboard header. The connector after the cable twist is for A:. If the drive light stays on solid as soon as you power on, the cable is flipped. Try another ribbon if you have one.
  • Boot test: See if the PC can boot from a known‑good bootable floppy. If it cannot boot or hangs before Windows loads, the issue is hardware (drive, cable, or the motherboard’s floppy controller).
  • Windows cleanup: In Device Manager, uninstall both “Floppy disk drive” and “Standard floppy disk controller,” then reboot to let XP reinstall them. Also check Event Viewer (System log) for BugCheck or floppy/controller errors to confirm it is driver vs. hardware.
  • Software conflicts: Temporarily disable real‑time antivirus or any tools that auto‑scan floppies. Try in Safe Mode to rule out third‑party filter drivers.
  • Physical: Clean the heads with a cleaning disk. If possible, test with another known‑good floppy drive.

If a replacement drive still BSODs, the motherboard’s floppy controller is likely at fault. Easiest workaround is to disable the onboard FDD in BIOS and use a USB floppy drive.

Recommended Answers

All 2 Replies

Member Avatar for TT4Titans

replace floppy drive.

Member Avatar for bondi007

i suppose so there only cheap

cheers:cool:

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.