Member Avatar for reypern73

Can anybody help me set-up/install my ibm 2212 router, I am connecting through the internet via DSL. I want to use my Router in my LAN. Thnx in advance.

  • 3 Contributors
  • 2 Replies
  • 90 Views
  • 3 Months Discussion Span
  • Latest Post Latest Post by TheNSS

Dani AI

Generated

A compact, practical checklist for getting an IBM 2212 onto a DSL link, plus common troubleshooting and security notes. This expands on 's original request, acknowledges 's offer of help, and puts 's hardware-replacement point into context (older gear can be fine, but may lack modern security).

Start with the physical and basic network steps: connect the DSL modem to the router WAN/Internet port and a PC to a LAN port, then power-cycle the modem first and the router second (wait for DSL sync on the modem). Set the PC to obtain an IP automatically and run ipconfig /all (Windows) or ip addr (Linux) to find the router gateway. Access the router web UI at that gateway IP and log in (check the unit label or manual for defaults; if unknown, a factory reset via the recessed button restores defaults). In the WAN/Internet settings choose the ISP connection type — PPPoE and enter ISP credentials if required, or use DHCP/automatic IP if the modem already authenticates. Ensure NAT is enabled and the LAN DHCP server hands out an address range that does not conflict with the modem.

Troubleshooting and hardening: check LED states for physical/link sync, confirm the router shows a WAN IP, and clone the PC MAC on the router if the ISP binds service to a single MAC. For double NAT either bridge the modem or switch the router to access-point mode. Back up the current config before any firmware update or reset. Change the admin password, disable remote management, enable strong Wi-Fi encryption (WPA2/AES or better if supported), and consider replacing very old hardware for better security and performance. Common diagnostics to report for deeper help: ISP connection type, modem model, and exact LED/status messages on the router.

Recommended Answers

All 2 Replies

Member Avatar for chrisplatt

most routers come with installation software. if this is the case then install yours and tell it what it needs to know. if you dont know what to put the post back and i'll help you out. btw is it new?

Member Avatar for TheNSS

if i were you, i wouldn't have bought an ibm router, they suck. get linksys or netgear.

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.