i see it has two memory channels, one black and one blue slot in each.
can i put 1 gb in each of the 4 slots?
if i were going to only install 2 1gb sticks, which color slots should i put them in?
i see it has two memory channels, one black and one blue slot in each.
can i put 1 gb in each of the 4 slots?
if i were going to only install 2 1gb sticks, which color slots should i put them in?
— good question. Useful points from and already point toward the manual and show that different DIMM mixes can work. The following clarifies what to check and what to do so the board runs reliably and at full performance.
Before installing: verify the motherboard memory specifications (DIMM type, per‑slot and total capacity, supported voltages/timings). If the 1GB modules match the board's supported type and density, four identical sticks are normally fine. Mixing sizes or speeds usually works but will typically force all modules to use the slowest common speed and may change how the memory controller maps channels. Also remember that a 32‑bit OS often cannot use the full 4GB of RAM due to address reservations; use a 64‑bit OS to address all installed memory.
After installing: check BIOS/UEFI for detected capacity, frequency and voltage. Use a utility such as CPU‑Z to confirm the memory channel mode and effective timings. For stability, run memtest86 (or the built‑in memory diagnostic) for several passes. If problems occur, reseat modules, try one DIMM at a time to isolate a bad stick, clear CMOS after major changes, and consider a BIOS update or consulting the motherboard QVL for compatible modules. These steps will help confirm whether the chosen configuration is supported and operating correctly.
Jump to Post— compdoc 3do you have the book that came with the board it should tell which slots to use and up to what size maximum each slot can handle. if you only use 2 stick you should probably place them in the same color slots to take advantage of the dual channel. …
do you have the book that came with the board it should tell which slots to use and up to what size maximum each slot can handle. if you only use 2 stick you should probably place them in the same color slots to take advantage of the dual channel. but read the book if you don't have it look for it on-line it wont be hard to find it.
yeah they must be installed in matching pairs in matching colours
e.g my config on my intel-based dell
1 (blue) 1gb
2 (yellow) 256mb
3 (blue) 1gb
4 (yellow) 256mb
this gives me 2.5gb of dual channel ram
We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.