0

If you know anything about this please help me out. I am about done building my new machine. Well, anyway I started it up just to make sure everything was working like I have always done before I finish. I shut it down and when I went to restart it it would flash on and off and on and off and would not stop until I shut off power. It would continue to do this until I reset cmos. I tried again and it did it again. If you are familiar with this problem or if there even is a problem let me know. Thanks.

3
Contributors
3
Replies
4
Views
9 Years
Discussion Span
Last Post by bobbyraw
0

make sure the processor is not overheated, reseat your processor and put enough thermal compound on your heatsink

0

My processor is 30 c on idle. That is with a sensor and on the mobod. It is a bios issue. It happened now after all install. It happens after I go in the bios. It registers a 99 which says it means to complete power off sequence. When I power off it restarts with no problem.

0

seem like a video problem, is the video was a PCi card or an onboard vga reseat the card or check the settings in the bios.

This topic has been dead for over six months. Start a new discussion instead.
Have something to contribute to this discussion? Please be thoughtful, detailed and courteous, and be sure to adhere to our posting rules.