Member Avatar for buddyb

I've seen this, but can't seem to find it. In one of the Icons in the Control Panel I believe you can see IP info, do release and renew, etc; and it's not through the "cmd" in the Run menu. Anyone aware of this?
Thanks, BuddyB

  • 3 Contributors
  • 4 Replies
  • 132 Views
  • 6 Days Discussion Span
  • Latest Post Latest Post by buddyb

Dani AI

Generated

Short version: there are both GUI and scripted ways to view adapter IP details and to force a DHCP release/renew. already pointed to the built‑in UI route, and was right that small scripts make a handy shortcut. Below are safe, simple scripts and setup tips you can apply immediately.

Save the following examples as .bat files (use Notepad and save with a .bat extension). The first shows details, the second performs a typical release/renew plus DNS flush, and the third is the TCP/IP reset command for deeper trouble‑shooting.

@echo off
ipconfig /all
pause
@echo off
ipconfig /release
ipconfig /renew
ipconfig /flushdns
pause
@echo off
netsh int ip reset
pause

After saving, create a shortcut to each .bat on the desktop. In the shortcut Properties set "Run" to "Minimized" to avoid big console windows. If the commands fail with permission errors, run them from an administrator account (changing adapter settings requires sufficient rights).

Quick troubleshooting notes:

  • If the adapter is set to a static IP, release/renew won’t change anything — check the IPv4 properties first.
  • Release/renew only works if a DHCP server (router, ISP) is reachable. If DHCP fails, try power‑cycling the modem/router.
  • Virtual adapters (VPN, VM software) can confuse which interface is being renewed — run ipconfig /all to confirm which adapter is active.
  • For persistent problems, netsh int ip reset followed by a reboot will rebuild the TCP/IP stack.

For official command details see Microsoft’s documentation for ipconfig and .

Recommended Answers

All 4 Replies

Member Avatar for kc0arf

Hello,

I seem to remember a graphical client to reset/renew the network interfaces, but I am pretty sure it wasn't a control panel.

Closest thing you might have to do to get this type of functionality is write some small batch files and attach them to icons.

Christian

Member Avatar for rasputinj

on NT and Windows 98 you could use "wntipcfg " in the run command for a graphical interface. But in XP you can

Go to Control Panel / Network Connections / Double click the icon for your network
Click on the Support tab
Click on the Details button

You can use the repair which I believe does a release and renew

Member Avatar for rasputinj

sorry double post.

Member Avatar for buddyb

You're absolutely correct about this. Thanks for the heads-up.
BuddyB

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.