Member Avatar for Centre Kinesis

The DLL problem has been fixed

but I am getting a new message on start up; here it is:

The instruction at 'ox7c9105f8' referenced memory at '0x00090010', the memory could not be read. Click on OK to terminate program.

The windows error message then pops up and asks me if i want to send the inf to windows.

any suggestions?

Thanks

  • 2 Contributors
  • 1 Reply
  • 76 Views
  • 9 Hours Discussion Span
  • Latest Post Latest Post by MidiMagic
Member Avatar for MidiMagic

Check for:
- spyware and viruses
- bad Windows install (reinstall)

Be a part of the DaniWeb community

We're a friendly, industry-focused community of developers, IT pros, digital marketers, and technology enthusiasts meeting, networking, learning, and sharing knowledge.